University of ModenaMScAcademicOct – Dec 2024

MotoGP Holeshot Device Hydraulic System

Kinematic model of a MotoGP holeshot device in MATLAB and its complete hydraulic circuit in OpenModelica: pump, accumulator, valves and actuators sized to lower the bike for the start and hold it under braking.

MATLABOpenModelicaReport

Lower the bike, but only at the start

MotoGP bikes use hydraulic devices that lower the front and the rear for the launch, to keep the front wheel down; since 2023 they are allowed only at the start. Their design is secret, so this course project started from photos and public data to size a complete system for a launch, a braking and the release.

The holeshot lever on the handlebar
The holeshot lever on the handlebar

Kinematics first, hydraulics next

With a colleague I modelled the rear linkage in MATLAB to find the load on the actuator, and sketched a simple front solution: an actuator that draws oil from the fork. The load transfer during launch and braking set the forces both actuators must hold.

We assumed a lowering of about 50 mm at both ends and a launch-and-brake manoeuvre with the load moving from 50/50 to 90/10 and back. The hydraulic circuit was then built in OpenModelica: an electric pump, an accumulator, two directional valves for engaging and releasing the device, pipes and the two actuators, each sized for pressure and flow.

Rear linkage with the hydraulic actuator
Rear linkage with the hydraulic actuator
Front actuator concept inside the fork
Front actuator concept inside the fork

Braking is the hard part

The system lowers both ends at the start and holds them through the acceleration. The critical moment is braking: almost all the weight moves to the front, the pump speeds up and the pressure peaks around 73 bar, safely below a relief valve set at 100 bar.

The rear actuator lets go quickly once the device is released, while the front one first gives way to the load transfer and then extends again as the pump picks up speed.

The complete circuit in OpenModelica
The complete circuit in OpenModelica
Front (red) and rear (blue) actuator strokes during the manoeuvre
Front (red) and rear (blue) actuator strokes during the manoeuvre
Project report OpenDownload PDF

Loading the report…

Questions about this project?

Book a call: the calendar opens right here.

All projects